proper use and maintenance of the Car Door Magnet product (hereafter
incorporated by reference into and made a part of the
By purchasing this Product, you agree to be bound by these
incorporated herein, carefully. If you do not wish to be
the Product to you.
- Prior to application, clean the metallic surface and
the Product with a mild detergent. Wipe with a soft
cloth and allow to dry.
- For best results, apply the
Product at room temperature.
- Use care in handling the
Product in extremely cold conditions, as the
magnetic material can become brittle.
- Long-term outdoor usage of
magnets on painted surfaces may result in fading,
due to shielding the underlying color from
- This car door magnet is not
for use under water or on aircraft.
- Make sure to remove the car
door magnet from any vehicle before a car wash.
- Determine the location to place the product
- Before affixing the Product
to a metal surface, be sure all surface paints,
clear coats and waxes are cured or hardened.
Approximate curing times are: paint - 90 days, clear
coat - 60 days, wax - 2 days.
- Choose a location that is
smooth, flat, or only mildly curved and metallic.
- Don't apply the Product on
an area that isn't steel or that has extensive
non-metallic fillers. Aluminum, wood or fiberglass
will not function as a surface.
- Affix the Product onto the surface.
- Ensure the Product is flat
over the entire surface.
- Ensure that there are no air
pockets and that the corners and edges are smooth
and flush with the the surface.
- Curvature on the edges of
the Product may result in the sign falling off.
- To adjust the location of
the Product after placement, remove completely and
reposition by lifting at the sides to remove, not
the corners. Please note that sliding the Product
into position may cause stretching.
* FAILURE TO FOLLOW ANY
OF THE FOREGOING INSTRUCTIONS MAY RESULT IN DAMAGE TO THE
PRODUCT ITSELF AND TO THE SURFACE ON WHICH THE PRODUCT IS
AFFIXED, AND MAY ALSO INCREASE THE LIKELIHOOD THAT THE
PRODUCT WILL NOT ADHERE PROPERLY AND MAY FALL OFF DURING
USE. NEITHER HARPWRO NOR ANY OF ITS OFFICERS, DIRECTORS, OR
OTHER AFFILIATES WILL BE LIABLE TO YOU OR ANY THIRD PARTY
FOR ANY CLAIMS, LOSSES OR OTHER DAMAGES TO THE PRODUCT, THE
SURFACE TO WHICH IT IS AFFIXED, OR ANY OTHER PROPERTY OR
PERSON, INCLUDING WITHOUT LIMITATION DAMAGES FOR PERSONAL
INJURY, CAUSED BY ANY ABUSE OR MISUSE OF THE PRODUCT OR
OTHER FAILURE TO FOLLOW THE INSTRUCTIONS.
Do's and Don'ts
Do remove the
Product daily for cleaning.
Do wipe both the Product and the metal surface with a
mild detergent. This helps protect the Product from moisture
and dirt buildup, and the underlying metal surface from dirt
Do Wipe the Product dry with a soft cloth or allow to air
Do allow 2 days for the wax to cure after waxing and
polishing before applying the Product.
Do store the Product in a clean, dry place when not in
Do store the Product flat or rolled and standing on end
to prevent creasing. If storing rolled, keep the printed
surface facing outward.
Don't place the Product over protrusions, fixtures or
concave areas, such as: molding, lights, reflectors, decals,
pin stripes, air intakes, wells and spoilers.
Don't apply the Product to horizontal metal surfaces
subject to direct sunlight and high heat, such as auto hoods.
Don't layer one Product on top of another when applied to
Don't place other objects on top of a stored Product.
Don't store with magnetic surfaces facing each other when
multiple Products are stored together.
Don't apply the Product onto any surface if it was stored
with the magnetic side facing outwards.